#Configuring tftp server password
#Configuring tftp server download

Enter up to 64 alphanumeric characters.ĭomain name of the device, for example support.hp.com. Path and file name whose contents are printed each time the print server is turned on. Default is NPIxxxxxx, where xxxxxx represents the last six digits of the LAN hardware address.

Node name that appears on the HP Jetdirect configuration page. Link local multicast name resolution (LLMNR).

Reset security settings on the print server to factory default values. Use only HTTPS (secure HTTP) communication.Ģ: Disable redirection to HTTPS. Print server’s security level for Web communication, using the following values:ġ: Forced redirection to the HTTPS port. Name of the network or device administrator (SNMP sysContact object) who administers or services the printer. Sys-contact: (or host-contact:, contact:) Physical location of the printer (SNMP sysLocation object). Sys-location: (or host-location:, location:)

#Configuring tftp server password

TFTP configuration file parameters General passwd: (or passwd-admin:)Īdministrator’s password to control access to HP Jetdirect print server configuration parameters using Telnet, HP Web Jetadmin, or the embedded Web server. (Optional commands for the same function are shown in parentheses.) This table describes the TFTP command parameters supported by HP Jetdirect print servers. Set-cmnt-name Community name required in SNMP Set commands. Trap-dest IP address of the system to send SNMP traps to. Use the embedded Web server.Īuth-trap Set to on. Cannot use Telnet.Įws-config Set to one (1). The following list describes the example TFTP configuration file settings: You can also specify single IP addresses for specific systems. Add up to 10 entries using TFTP, Telnet, or the embedded Web server. This specifies a host or network of hosts that can connect to the print server. Set allow to enable subnet 192.168.10.0 with access to the printer. (The # symbol signifies a remark and is not included in the file.)Įxample HP Jetdirect TFTP configuration file The following is an example of a TFTP configuration file. This TFTP configuration file’s relative path name is specified in the BOOTP reply using the /etc/bootptab file’s T144 vendor-specific tag, or the ef standard BOOTP tag entry.

#Configuring tftp server download

To provide additional configuration parameters for your HP Jetdirect print server, such as SNMP or non-default settings, you can download a configuration file using TFTP.